Online - Inline pH electrode systems
MODEL : ITS-pH501
INR @ 18,500.00
pH Range : 0 To 14.00 pH
Accuracy +/- 0.01pH
BNC End Plug Supplied With Epoxy Body Unbreakable pH
Electrode and Assemblies.
The measuring of pH within a piece of pipework is a common method of ensuring that a process pH is with in the desired parameters.
An alternative to installing a threaded pH probe either directly into pipework or within a tee piece, is to use an inline pH electrode system.
An inline pH electrode system allows a pH electrode to be installed into a piece of pipe work for the precision measurement of process pH. Our standard inline pH electrode systems are of a fixed size and are a neat solution to measuring pH inline, allowing the pH electrode to remain securely in position. Removal is simple, with the quick release fitting and when solvent welded into place, they become a permanent piece of the pipework.
Our inline pH electrode systems include a mechanism for the quick release of the pH electrode When the probe can be easily removed, this makes periodic buffering and calibration of the pH electrode a quick and clean process.
We do recommend installing isolation valves and a bypass before and after an inline pH electrode system. The only exception to this is our lock-n-load retractable pH electrode system. The lock-n-load is self isolating, meaning that the pH probe can be removed, even when there is fluid running through the pipework. This is fantastic if the process is critical and cannot be stopped, even to allow the pH electrode to be buffered.
When measuring the pH of a process that is contained within a pipe it can be tempting to thread the pipe and install a pH probe with the corresponding thread. This can sometimes cause difficulty when it comes to removing the probe, either for maintenance, replacement or for a standard calibration. For an easy way to remove the pH sensor we recommend using one of our inline pH electrode systems. We have the assembly for 3by4 pipework and the inline pH electrode system for larger diameter pipes.
These two systems are solvent welded into the pipework, or they can be supplied with threaded connections on request, to form an integral part of the pipe work. Then when its time to remove the pH electrode and the pipework has been drained and isolated, the pH electrode is removed from the inline electrode system using the quick release fitting. This takes a matter of minutes for easy maintenance.
Alternatively we have the This system is sealed from inside the end cap so the retracting section of the Lock Load wonot fly off under pressure and it also creates a seal with the pipework. When its locked into place, the pH electrode can be removed without having to isolate and drain the pipework. Its a neat all in-one-system, which means that there is not a convoluted arrangement of ball valves or retaining cables, just a simple lift, twist and lock to remove the electrode and carry out any maintenance.